Daedong EX50-SA - When Operating the P.t.o

EX50-SA / EX55-SA / EX5310-AU / EX5810-AU
1
-
14
WHEN OPERATING THE P.T.O.
1. Make sure the tractor is completely
stopped, gears are in neutral and
all moving components have com-
pletely stopped before connecting,
disconnecting, adjusting, clean-
ing or servicing any P.T.O driven
equipment.
2. Keep the P.T.O shaft cover in place
at all times. Replace the P.T.O
shaft cap when the shaft is not in
use.
3. Before installing or using P.T.O
driven equipment, read the man-
ufacturer's manual and review the
safety labels attached to the equip-
ment.
WARNING
•
Before driving an implement
through the PTO, always make
sure that all bystanders are well
away from the tractor.
•
When using the PTO drive with a
stationary tractor, always make
sure that the gears are in neutral
and that the parking brake is ap-
plied.
•
Before starting up any PTO-driv-
en implement hitched to the
three-point linkage, lift the imple-
ment to its full height and check
that at least 1/4 of the total length
of the telescopic section of the
drive shaft is engaged.
•
Ensure that implements and at-
tachments are properly installed
and that the tractor and imple-
ment PTO RPM ratings match.
T66O122A
4. When operating stationary P.T.O
driven equipment, always apply
the tractor parking brake and place
chocks behind and in front of the
rear wheels. Stay clear of all rotat-
ing parts.
5. Do not attach a PTO driven imple-
ment if the implements safety
shields are damaged or not in
place. Rotating shafts are an en-
tanglement hazard.
(1) PTO Shield
(2) PTO Shaft Cap
T46O121A
TE150 (EX50, EX55)-���-01.indd 14 2019-03-19 �� 2:45:43