Daedong EX50-SA - USING TRACTOR AFTER STORAGE; USAGE AND DISPOSAL

EX50-SA / EX55-SA / EX5310-AU / EX5810-AU
8
-
4
1. Check the tire air pressure and
inatethetiresiftheyarelow.
2. Install a fully charged battery.
3. Check the fan belt tension.
4.Checkalluidlevels.(Engineoil,
transmission/hydraulic oil, engine
coolant and any attached imple-
ments)
5. Check the urea level in the tank
and add urea as necessary.
6. Remove grease from the ex-
posed cylinder rod.
7. Apply grease to the lubrication
points.
8. Remove the cover from the ex-
haust pipe.
9. Get onto the tractor and start the
engine.
10. Check if the instrument panel
and all parts operate correctly
while running the engine for a
few minutes.
USING TRACTOR AFTER STORAGE USAGE AND DISPOSAL
In order to protect the environment,
use and dispose of the tractor keep-
ing the following in mind :
1. When changing the oil or coolant
by yourself, be careful not to spill it
and dispose used oil and coolant
properly according to the appli-
cable regulations.
2. Never leave or discard the expired
tractor or implement, but contact
your local
KIOTI
Dealer to dispose
it according to the regulations.
3. Avoid working under high load as it
can cause excessive exhaust gas,
which is harmful to the environ-
ment.
11. Drive the tractor outside and
check if it is operating properly.
Park the tractor outside and idle
engine for at least 5 minutes.
Stop the engine and visually in-
spect the tractor. Check if there
is leakage.
12. Start the engine, release the
parking brake, and check the
brake condition while driving for-
ward. Adjust the brake pedals if
necessary.
13. Stop the engine and check for
leakage. Repair any part as re-
quired.
TE150 (EX50, EX55)-���-08.indd 4 2019-03-19 �� 2:33:40