Daedong EX50-SA - Power Steering Line(Aa); Adjusting Front Axle Pivot(Ad)

7
MAINTENANCE
7
-
29
Take the following actions in the
event the coolant temperature reach-
es the boiling point, what is called
"Over-heating".
1. Stop the machine in a safe place
and keep the engine idling.
2. After 5 minutes of unloaded idling,
shut the engine down.
3. Keep yourself away from the trac-
tor for another 10 minutes or until
steam has stopped blowing out of
the engine.
4. Make sure that there is not danger
and repair the cause of the over-
heating according to the manual’s
instruction. (Make sure to refer to
"Engine troubleshooting" in chap-
ter 8 before starting the engine)
PRECAUTION AT OVERHEATING
(1) Power Steering Oil Line
POWER STEERING LINE(AA)
1. Check to see that all hydraulic
lines and hose ttings are tight and
undamaged.
2. If damage is found you should re-
place the hose at once.
TE5O708A
ADJUSTING FRONT AXLE PIV-
OT(AD)
If the front axle pivot pin adjustment
is not correct, front wheel vibration
can occur causing vibration in the
steering wheel
ADJUSTING PROCEDURE
Loosen the lock nut, tighten the ad-
justing screw all the way, and then
loosen the screw by 1/6 turn. Re-
tighten the lock nut.
(1) Lock Nut (2) Adjusting Screw
T46OA38A
TE150 (EX50, EX55)-���-07.indd 29 2019-03-19 �� 4:36:29