Daedong EX50-SA - Flush Cooling System and Changing Coolant(Aj)

7
MAINTENANCE
7
-
31
Coolant capacity
8.7 L [2.3 U.S.gal.]
To avoid accidents :
•
Do not remove the radia-
tor cap while the coolant is
hot. You can get burnt by hot
steam. Make sure to remove
it after the coolant is cooled
down enough.
•
Even though the coolant is
cooled down, turn the cap to
its rst stop and then wait un-
til it is depressurized before
removing the cap completely.
CAUTION
FLUSH COOLING SYSTEM AND
CHANGING COOLANT(AJ)
(1) Drain Cock
1. Stop the engine and let it cool.
2. To drain the coolant, open the radi-
ator drain cock and remove radia-
tor cap. The radiator cap must be
removed to completely drain the
coolant.
3. After all coolant is drained, close
the drain cock.
4. Fill with clean water and cooling
system cleaner.
5. Follow the cleaner manufacture’s
instruction.
T46OA39A
(1) Reservoir Tank (2) Radiator Cap
(A) FULL (B) LOW
6. Add water only up to the "LOW"
mark or higher level of the reservoir
tank.
7. Start and operate the engine for
few minutes.
8. Stop the engine and let it cool.
9. Check coolant level of reservoir
tank and radiator. Add coolant if
necessary.
T46OA40A
TE150 (EX50, EX55)-���-07.indd 31 2019-03-19 �� 4:36:30