7
-
39
(1) Turn Signal Lamp Bulb
3. With the bulb pressed downward,
turn it counterclockwise to remove
it. Replace it with a new one.
M46O744A
•
Do not touch the bulb if it is
still illuminated or right after
it is turned "OFF". You can be
burned by the hot bulb.
•
For some bulbs which require
delicate handling or work pro-
cess, contact your local KIOTI
Dealer.
•
Do not touch the illuminating
glass part of the halogen bulb.
The bulb life can be shortened
by finger prints, dust and
moisture, or the bulb even can
be broken. Clean it with soft
cloth.
•
The halogen bulb contains
compressed gas, so it can ex-
plode if dropping or scratch-
ing it. Therefore, never use a
bulb if it is scratched or was
dropped.
CAUTION
•
When separating the cover by
prying it "OFF" with a screw-
driver, be careful not to dam-
age it.
•
Before replacing a bulb, make
sure to put the key switch and
the switch for the correspond-
ing bulb to the "OFF" position.
•
Install a new bulb with the
same capacity after removing
the installed bulb.
CAUTION
TE150 (EX50, EX55)-���-07.indd 39 2019-03-19 �� 4:36:33
To Next Page
Loading...
