TIRES, WHEELS AND BALLAST .......................... 4-32
GENERAL TIRE INFORMATION ................................... 4-32
INFLATION PRESSURE ............................................... 4-33
TREAD........................................................................... 4-34
WHEEL TORQUE AND DIRECTION ............................. 4-35
ADDITIONAL WEIGHT(OPTIONAL) ............................ 4-36
OPERATION ........................................................5-1
PRE-OPERATION ..................................................... 5-2
INITIAL OPERATION ................................................ 5-3
OPERATING THE ENGINE ...................................... 5-3
STARTING THE ENGINE ................................................ 5-3
STOPPING THE ENGINE ............................................... 5-8
WARMING UP ................................................................. 5-9
JUMP STARTING .......................................................... 5-10
OPERATING THE TRACTOR ................................. 5-11
HOW TO DRIVE .............................................................5-11
HOW TO FOLD THE ROPS .......................................... 5-14
HOW TO RAISE THE ROPS TO UPRIGHT POSITION ... 5-15
PARKING ....................................................................... 5-16
TURNING ...................................................................... 5-18
DRIVING ON SLOPE .................................................... 5-18
THE CAUTIONS WHEN COMING IN AND OUT OF
PAVED ROAD ............................................................ 5-19
PRECAUTIONS WHILE DRIVING ON THE ROAD ...... 5-20
LOADING INTO AND UNLOADING OUT OF THE
TRUCK ....................................................................... 5-21
PRECAUTIONS WHEN USING POWER STEERING .. 5-21
3-POINT HITCH CONTROL SYSTEM .......................... 5-23
EXTERIOR HYDRAULIC CONTROL SYSTEM ............ 5-27
3-POINT HITCH IMPLEMENT AND LOADER
OPERATION ......................................................6-1
REMOVAL AND INSTALLATION OF 3-POINT
HITCH IMPLEMENT (WITH PTO SHAFT) ............ 6-2
OPERATION TIP FOR 3-POINT HITCH ELEMENTS .... 6-5
ADJUSTMENT OF LIFT ROD ......................................... 6-5
ADJUSTMENT OF TOP LINK ........................................ 6-6
PRECAUTION FOR INSTALLING HOW TO USE
TOP LINK HOLES ........................................................ 6-6
ADJUSTMENT OF STABILIZER ..................................... 6-7
DRAFT HITCH AND TRAILER ........................................ 6-7
TABLE OF CONTENTS
TE150 (EX50, EX55)-���-00.indd 6 2019-03-19 �� 6:46:03
To Next Page
Loading...
