Name: Dahua DHI-NVR608R-64-4KS2
Brand: Dahua
Rating: 4 (1 reviews)

To Next Page

To Previous Page

168

type:Regular/MD/Alarm/MD&Alarm. Please note, you cannot select the MD&Alarm and MD(or

Alarm) at the same time.

 Now you can go to the Encode interface to select the alarm record and set the encode

parameter (Main Menu->Setting->Encode).

 Finally, you can set the alarm input as the local alarm and then select the record channel. The

select channel begins alarm record when an alarm occurred. Please note system begins the

alarm record instead of the MD record if the local alarm and MD event occurred at the same

time.

 Tour: Here you can enable tour function when an alarm occurs. System supports 1/8-window tour.

Please go to chapter3.6.6.1 Display for tour interval setup. Please note the tour setup here has

higher priority than the tour setup you set in the Display interface. Once there two tours are both

enabled, system can enable the alarm tour as you set here when an alarm occurred. If there is no

alarm, system implements the tour setup in the Display interface.

 Snapshot: You can enable this function to snapshot image when an alarm occurs.

 Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.

Figure 3-156

Other manuals for Dahua DHI-NVR608R-64-4KS2

Questions and Answers:

Need help?

Do you have a question about the Dahua DHI-NVR608R-64-4KS2 and is the answer not in the manual?

General