287
Figure 4-49
4.6.2.11 Alarm Centre
The alarm center interface is shown as below. See Figure 4-50.
This interface is reserved for you to develop. System can upload alarm signal to the alarm center when
local alarm occurs.
Before you use alarm center, please set server IP, port and etc. When an alarm occurs, system can send
out data as the protocol defined, so the client-end can get the data.
Figure 4-50
4.6.2.12 P2P
You can use your cell phone to scan the QR code and add it to the cell phone client.
Via the SN from scanning the QR code, you can access the device in the WAN. Please refer to the P2P
operation manual included in the resources CD.
The P2P interface is shown as in Figure 4-51.
To Next Page
Loading...
Need help?
General
