Name: Dahua DHI-NVR608R-64-4KS2
Brand: Dahua
Rating: 4 (1 reviews)

To Next Page

To Previous Page

232

Step 3 Input group name and select one or more channels.

Step 4 Click Save button to complete broadcast group setup.

Note

On the broadcast interface, click to change group setup, click to delete group.

After complete broadcast setup, on the preview interface and then click on the navigation

bar, device pops up broadcast diaologue box. Select a group name and then click to

begin broadcast. See Figure 3-229.

Figure 3-229

3.13.7 Security

3.13.7.1 IP Filter

IP filter interface is shown as in Figure 3-230. You can add IP in the following list. The list supports max 64

IP addresses. System supports valid address of IPv4 and IPv6. Please note system needs to check the

validity of all IPv6 addresses and implement optimization.

After you enabled trusted sites function, only the IP listed below can access current NVR.

If you enable blocked sites function, the following listed IP addresses cannot access current NVR.

 Enable: Highlight the box here, you can check the trusted site function and blocked sites function.

You cannot see these two modes if the Enable button is grey.

 Type: You can select trusted site and blacklist from the dropdown list. You can view the IP address

on the following column.

Other manuals for Dahua DHI-NVR608R-64-4KS2

Questions and Answers:

Need help?

Do you have a question about the Dahua DHI-NVR608R-64-4KS2 and is the answer not in the manual?

General