38
Figure 3-12
Step 4 Click Apply button to save settings.
3.4.1.2 Date and Time
Here you can set device time. You can enable NTP (Network Time Protocol) function so that the device
can sync time with the NTP server.
Step 1 Click Date and time button. See Figure 3-13.
Note
From Main menu>Setting>System>General>Date and time, you can go to the date and time
interface.
Date format: There are three types: YYYYY-MM-DD: MM-DD-YYYYY or DD-MM-YYYY.
Time format: You can select 24-hour or 12-hour time format.
Date separator: There are three denotations to separate date: dot, beeline and solidus.
System time: Displays the current system time.
DST: Here you can set DST time and date by week or by date. Please enable DST function
and then select setup mode. Please input start time and end time and click Save button.
Time format: There are two types: 24-hour mode or 12-hour mode.
NTP: It is to set NTP server, port and interval.
Warning
System time is very important; do not modify time casually unless there is a must!
To Next Page
Loading...
Need help?
General
