290
Parameter Description
PTZ
Activation
Select the check box and click Setting. Select the PTZ channel and PTZ
action. When an alarm occurs, NVR triggers the channel to perform the
corresponding PTZ action. For example, activate the PTZ to move to preset
point X.
Note
You shall set the corresponding PTZ actions first.
Tour
Select the check box and click Setting. Select the tour channel. When an
alarm occurs, NVR local interface displays the select channel image.
Note
You shall set tour interval and tour mode first.
Snapshot
Select the check box and click Setting. Select the snapshot channel. When an
alarm occurs, NVR triggers snapshot in the selected channel.
Note
You shall enable alarm snapshot and auto snapshot first.
Log
Select the check box. When an alarm occurs, NVR records the alarm
information in the log.
Buzzer
Select the check box. When an alarm occurs, NVR triggers the buzzer for
alarm.
Step 4 Click OK or apply to save the configuration.
4.6.3.2 Rule Settings
It is to set the temp rules and temp comprison and trigger the alarm output when the temp meets
the set alarm condition.
4.6.3.2.1 Temp Rule
Step 1 Select Setup > Temperature Measurement > Rule > Setup.
Thr Setup interface is displayed. See Figure 4-53
To Next Page
Loading...
Need help?
General
