28
3 Local Basic Operation
3.1 Boot up and Shutdown
3.1.1
Boot up
CAUTION
Before the boot up, please make sure:
The voltage of power supply matches with the device power on-off button.
For device security, connect the NVR to the power adapter first, make sure the power connection is
ok, and then turn on the power on-off button.
Always use the stable current with little ripple interference. UPS is recommended.
Step 1 Connect the device to the monitor or display and then connect a mouse.
Step 2 Connect power cable.
Step 3 Click the power button on the front or rear panel and then boot up the device. After device boots
up, the system is in multiple-channel preview mode by default.
3.1.2 Shutdown
CAUTION
When you see corresponding dialogue box “System is shutting down…” Do not click power on-off
button directly.
Do not unplug the power cable or click power on-off button to shutdown the device directly when the
device is running (especially when it is recording.)
There are three ways for you to log out.
(RECOMMENDED) From Main Menu > Shutdown and select shutdown from dropdown list.
Press the power on-off button on the NVR front panel or remote control for more than 3 seconds
to shut down the device.
Press the power on-off button on the rear panel.
3.2 Device Initialization
If it is your first time to use the device, please set a login password of admin (system default user). You
can select to use unlock pattern to login or not at your own choosing.
Note
For your device safety, please keep your login password of admin well after the initialization steps, and
change the password regularly.
Please follow the steps listed below.
Step 1 Boot up NVR.
Device displays device initialization interface. See Figure 3-1.
To Next Page
Loading...
Need help?
General
