298
Parameter Description
PTZ
Activation
Select the check box and click Setting. Select the PTZ channel and PTZ
action. When an alarm occurs, NVR triggers the channel to perform the
corresponding PTZ action. For example, activate the PTZ to move to preset
point X.
Note
You shall set the corresponding PTZ actions first.
Tour
Select the check box and click Setting. Select the tour channel. When an
alarm occurs, NVR local interface displays the select channel image.
Note
You shall set tour interval and tour mode first.
Snapshot
Select the check box and click Setting. Select the snapshot channel. When an
alarm occurs, NVR triggers snapshot in the selected channel.
Note
You shall enable alarm snapshot and auto snapshot first.
Send Email
Select the check box. When an alarm occurs, NVR semds email to the set
mail box.
Note
You shall configure the Email first.
Buzzer
Select the check box. When an alarm occurs, NVR triggers the buzzer for
alarm.
Log
Select the check box. When an alarm occurs, NVR records the alarm
information in the log.
Step 4 Click OK or Apply to save the configuration.
4.6.3.5 Hot Trace
After hot trace function is enable, the system displays the highest temp and lowest temp in different colors
on the monitor screen.
Note
Only the devices with temperature measurement function support this function.
Step 1 Select Setup > Temperature Measurement > Hot Trace.
The Hot Trace interface is displayed. See Figure 4-60