Dahua XVR5104HS User Manual

553
Parameter
Function
Period
Set tripwire valid period. System generates an alarm during the specified
period. For detailed setups, please refer to chapter 5.10.3.1.1 motion detect.
Step 6 Click Save to complete setup.
5.10.3.2.3 Abandoned Object Detect
It is to detect there is any abandoned object in the surveillance area for the specified time.
Note:
 The abandoned object detection function is valid once your network camera or your
DVR supports this function.
 If you want to use the IVS function of the network camera, please make sure your
connected network camera supports this function.
Step 1 From main menu->Setup->Event->IVS, click to add the rule. Select rule
type as abandoned object detection.
Note
Double click to change a rule name.
Step 2 Check the box to enable abandoned object detection function. See Figure 5- 82.
Figure 5- 82
Step 3 Click Draw rule to draw the rule. See Figure 5- 83. Left click mouse to draw a line,
until you draw a rectangle, you can right click mouse.

Dahua XVR5104HS Specifications

General

Video Compression	H.265+/H.265/H.264+/H.264
Audio Input/Output	1/1, RCA
Video Output	1 HDMI, 1 VGA
Network Interface	1 RJ-45 Port (100M)
Main Processor	Embedded Processor
Operating System	Embedded LINUX
Bit Rate	32Kbps ~ 6144Kbps per channel
Operating Temperature	-10°C ~ +55°C (+14°F ~ +131°F)
IP Video Input	4+2 channel, each channel up to 6MP
Analog Video Input	4 channel, BNC
USB Interface	2x USB 2.0
HDD	1 SATA port, up to 6TB
Dimensions	260mm x 236mm x 48mm
HDCVI Camera Input	4 channels
AHD Camera Input	4 channels
TVI Camera Input	4 channels
Operating Humidity	10% ~ 90%
Resolution	1080N, 720p, 960H, D1, CIF
Record Rate	Up to 25/30fps