Design Guide | VLT® AutomationDrive FC 360
1 Introduction
1.1 Purpose of the Design Guide
This design guide is intended for qualified personnel, such as:
l Project and systems engineers.
l Design consultants.
l Application and product specialists.
The design guide provides technical information to understand the capabilities of the drive for integration into motor control and
monitoring systems. Its purpose is to provide design considerations and planning data for integration of the drive into a system. It caters
for selection of drives and options for a diversity of applications and installations. Reviewing the detailed product information in the
design stage enables developing a well-conceived system with optimal functionality and efficiency.
This manual is targeted at a worldwide audience. Therefore, wherever occurring, both SI and imperial units are shown.
VLT® is a registered trademark for Danfoss A/S.
1.2 Additional Resources
Other resources are available to understand advanced drive functions and programming.
l The operating guide provides detailed information for the installation and start-up of the drive.
l The programming guide provides greater detail on working with parameters and many application examples.
l Instructions for operation with optional equipment.
Supplementary publications and manuals are available from Danfoss website www.danfoss.com.
1.3 Document Version
This guide is regularly reviewed and updated. All suggestions for improvement are welcome.
The original language of this manual is English.
Table 1: Document Version
Edition Remarks
AJ435824192086, version 0101 First edition.
1.4 Approvals and Certifications
1.4.1 CE Mark
The CE mark (Conformité Européenne) indicates that the product manufacturer conforms to all applicable EU directives.
The EU directives applicable to the design and manufacture of drives are:
l The Low Voltage Directive.
l The EMC Directive.
l The Machinery Directive (for units with an integrated safety function).
The CE mark is intended to eliminate technical barriers to free trade between the EC and EFTA states inside the ECU. The CE mark does
not regulate the quality of the product. Technical specifications cannot be deduced from the CE mark.
Danfoss A/S © 2024.01 AJ435824192086en-000101 / 130R1295 | 9
To Next Page
Loading...
Need help?
General