Danfoss VLT AutomationDrive FC 360 Design Guide

6 Mechanical Installation Considerations
6.1 Storage
Store the drive in a dry location. Keep the equipment sealed in its packaging until installation. Refer to chapter Ambient Conditions for
recommended ambient temperature.
Periodic forming (capacitor charging) is not necessary during storage unless storage exceeds 12 months.
6.2 Lifting the Unit
Always lift the drive using the dedicated lifting eyes. To avoid bending the lifting holes, use a bar.
 WARNING
RISK OF INJURY OR DEATH
Follow local safety regulations for lifting heavy weights. Failure to follow recommendations and local safety regulations can result
in death or serious injury.
l Ensure that the lifting equipment is in proper working condition.
l See chapter Product Overview and Features for the weight of the different enclosure sizes.
l Maximum diameter for bar: 20 mm (0.8 in).
l The angle from the top of the drive to the lifting cable: 60° or greater.
e30bv158.10
65
°
min
Figure 18: Recommended Lifting Method
44 | Danfoss A/S © 2024.01 AJ435824192086en-000101 / 130R1295
Design Guide | VLT® AutomationDrive FC 360

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English