DataCard SD260L - Load the Cleaning Sleeve; Install the Ribbon Cartridge

24 Using the System
3. Loadafullrollofprintribbon(thebluespool)onto
thebluespindleclosesttothecartridgehandleuntilit
clicksintoplace.
4. Placethesilvertake‐upspoolonthesilverspindle
withtheblackgearuntilitclicksintoplace.
5. Windthetake‐upspoolcounterclockwise
onefull
turn.
Load the Cleaning Sleeve
Loadanewcleaningsleevewhenyouloadanewrollof
printribbon,whenyounoticedebrisontheprinted
cards,orwhenthecleaningsleeveisnolongersticky.
1. Removethecleaningrollerspindlefromtheribbon
cartridge.
2. Slidethespindleintothecontinuouscleaning
sleeve(a).
3. Place
thespindlewiththecleaningsleeveontothe
ribboncartridge(b).
4. Removetheprotectivewrapperfromthecleaningsleeve(c).
Install the Ribbon Cartridge
Installtheassembledprintribboncartridgeintotheprinter.
1. Opentheprintercover.
2. Holdtheprintribboncartridgebythehandleandlowerit
intotheprinterwiththehandletowardthefrontofthe
printer.
3. Makesurethattheribboncartridgeiscorrectly
positionedintheguides.
4. Closethe
printercover.Pressdownontheridgesonthe
frontofthecovertomakesurethatitlatchesproperlyon
bothsides.