DataCard SD260L - 198: L1 Area Card Problem; 199: L2 Area Card Problem; 200: Laminator Exit Card Problem; 201: L1 Supply Problem

SD260L/SD360/SD460 Card Printers User’s Guide 69
198: L1 area card problem
Thecardisnotwhereitshouldbeinthelaminator.
1. OpenthelaminatorandremovetheL1supplycartridge.
2. Turntheknobtoremovethecard.
3. Replacethesupplycartridgeandclosethelaminator.
199: L2 area card problem
Thecardisnotwhereitshouldbeinthelaminator.
1. OpenthelaminatorandremovetheL2supplycartridge.
2. Turntheknobtoremovethecard.
3. Replacethesupplycartridgeandclosethelaminator.
200: Laminator exit card problem
Thecardisnotwhereitshouldbeinthelaminator.
1. Openthelaminator.
2. Turntheknobtoremovethecard.
3. Closethelaminator.
201: L1 supply problem
TheL1supplyisnotmovingproperly.Totryanothercard:
1. OpenthelaminatorandremovetheL1cartridge.
2. Reposition,repair,orreplacethesupplyandadvancetherepairedareaonefullturn.
3. Replacethecartridgeandclosethelaminator.
202: L1 supply out or missing
Thelaminator doesnothaveusablesupplies.
1. Openthelaminator.
2. Replacethesupply.
3. Closethelaminator.