DataCard SD260L - 172: Insert Cleaning Card; 173: Improper Shutdown; Laminator Messages; 177: Laminator Not Available

68 Troubleshooting
172: Insert cleaning card
1. Insertcleaningcard.
2. Ifthecardisnotimmediatelypicked,presstheprinter’sU
SERbuttonorclickOK.
ClickCancelifyouwanttocancelthecleaningcard.
173: Improper shutdown
AlwaysusethePOWERbuttontopowerofftheprinter.
PressandholdtheU
SERbuttontosettheprintertoReady .
ClickOKtoclearthemessage.
Laminator Messages
ThefollowingmessagesdisplayontheprinterLCDpanelwhenyouareusinganSD460laminating
system.TheyalsodisplayinamessageonthePCthatissuedthecardprintjob.
177: Laminator not available
Theprinterandlaminatorcannotcommunicate.Thecardwillbecanceled.
1. Makesurethedatacablefromthelaminatortotheprinterissecurelypluggedin.
2. PresstheprinterP
OWERbuttontopoweroffthesystem.
3. PressthePOWERbuttonagaintopoweronthesystem.
196: Laminator error critical
Thelaminatorhasencounteredacriticalerror.Thecardwillbecanceled.
1. PresstheprinterP
OWERbuttontopoweroffthesystem.
2. Requestservice.Thesystemmustremainpoweredoff.
197: Laminator entry card problem
Thecardisnotwhereitshouldbeinthelaminator.
1. Openthelaminator.
2. Turntheknobtoremovethecard.
3. Closethelaminator.