DataCard SD260L - Page 97

SD260L/SD360/SD460 Card Printers User’s Guide A-9
5. Loadthenewrolloflaminatoroverlaymaterial.
a. Putthebluesupplyspoolonthebluesupply
spindleofthecartridge(c).Theoverlay
supplyrollcangoononlyonewayandonly
fitsonthecorrectspindle.
b. Puttheemptysilvertake‐upspoolonthe
silver
take‐upspindle(d).
c. Turnthetake‐upspoolclockwisetoremove
slackfromthematerial(e).Theoverlay
materialloadsinanS‐shape.
Makesurethattheoverlaymaterialis
betweentheguidesonboththetake‐up
andsupplysidesofthecartridge.
6. Closethelaminatorcartridgegate
(f).Pushitin
untilthelatchclicksinplace (g).Makesure that
theoverlaymaterialisnotpinchedbythe
cartridgegate.
7. Replacetheloadedlaminatorcartridgeinthe
printer.
8. RemovetheL2(orange)cartridge,ifinstalled,
fromthelaminator.
9. Repeatsteps3through7toloadtheoverlay
onto
thecartridge.
10. Closethelaminatoraccessdoor.