Disconnect the power supply when
opening the device during maintenance
or installation to avoid exposure to
hazardous laser light.
The laser diode used in this device is
classified as a class 3B laser product
according to EN 60825-1 regulations
and as a Class IIIb laser product
according to CDRH regulations.
Any violation of the optic parts in
particular can cause radiation up to the
maximum level of the laser diode (35
mW at 630 to 680 nm).
AVOID EXPOSURE LASER LIGHT
IS EMITTED FROM THIS APERTURE
CAUTION-CLASS 3B LASER LIGHT
WHEN OPEN AVOID EXPOSURE TO BEAM
This product conforms to the
applicable requirements
of 21CFR1040 at the
date of manufacture
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVE LENGTH 630~680 nm
TO EN 60825-1:2001
Pat. US5992740, EP0789315B1
DATALOGIC AUTOMATION Srl
Via S. Vitalino, 13 – 40012 Calderara di Reno
MADE IN ITALY-
www.datalogic.com
Warning and Device Class Labels
POWER SUPPLY
- This product is intended to be installed by Qualified Personnel only.
- All Models:
This accessory device is intended to be supplied by a UL Listed or CSA Certified
Power Unit with «Class 2» or LPS power source, which supplies power directly
to the scanner via the 25-pin connector.
CE COMPLIANCE
Warning:
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
WEEE COMPLIANCE
viii
To Next Page
Loading...
Need help?
General
Weight and Dimensions
