Datalogic DS2400N User Manual

DS2400N
1
C-BOX 100/150 Pinout for DS2400N
The table below gives the pinout of the C-BOX 100/150 terminal block connectors.
Use this pinout when the DS2400N reader is connected in a network by means of the
C-BOX 100/150:
C-BOX 100/150 Terminal Block Connectors
Power Outputs
1, 3, 5 VS 21 OUT 1+
2, 4, 6 GND 22 OUT 1-
7, 8 EARTH GROUND 23 OUT 2+
20, 40 Reserved 24 OUT 2-
Inputs
25 NC
27
EXT TRIG A (polarity
insensitive)
26 NC
28
EXT TRIG B (polarity
insensitive)
Auxiliary Interface
29 NC 35 TX AUX
30 IN2- 37 RX AUX
31, 33 NC
ID-NET™
32, 34 NC 36 ID-NET-
39 GND 38 ID-NET+
Main Interface
RS232
RS485 Full-
Duplex
RS485 Half-Duplex
20 mA C.L.
(with INT-30 only)
11, 15 TX 232 TX 485+ RTX 485+
12, 16 RTS 232 TX 485- RTX 485-
17 RX 232 RX 485+
18 CTS 232 RX 485-
10, 14,
19
SGND SGND SGND
9, 13
RS485 Cable
Shield
RS485 Cable Shield
see INT-30
instructions
CAUTION
Do not connect GND and SGND to different (external) ground
references. GND and SGND are internally connected through
filtering circuitry which can be permanently damaged if subjected to
voltage drops over 0.8 Vdc.
2

Datalogic DS2400N Specifications

General

Type	-
Sensor type	Laser
Read rate (max)	1000 reads/s
Linear (1D) barcodes supported	Codabar, Code 128, Code 39, Code 93, GS1-128 (UCC/EAN-128), Pharmacode, U.P.C.
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	RS-232, RS-485
Connectivity technology	Wired
Input voltage	10 - 30 V
Power source type	DC
Power consumption (typical)	5 W
Certification	IEC
Product color	Blue, Yellow
Housing material	Aluminum
International Protection (IP) code	IP65
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	0 - 90 %

Weight and Dimensions

Depth	34 mm
Width	84 mm
Height	68 mm
Weight	330 g