Scale Features
Product Reference Guide 6-57
Scale Calibration Notification
When enabled, this feature allows the host to be notified of a calibration
event.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the two bar codes below. You’ll need to
cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
SCALE CALIBRATION NOTIFICATION = DISABLE
SCALE CALIBRATION NOTIFICATION = ENABLE
To Next Page
Loading...
Need help?
General
