EAN-8 Enable
Product Reference Guide 6-207
EAN-8/JAN-8 Both Guards Substitution
Enables/disables the ability of the scanner to find an EAN/JAN8 guard
pattern in cases where the EAN/JAN8 margin makes the guard look like a
character.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
EAN-8/JAN-8 BOTH GUARDS SUBSTITUTION = DISABLE
EAN-8/JAN-8 BOTH GUARDS SUBSTITUTION = ENABLE
To Next Page
Loading...
Need help?
General
