Keyboard Wedge/USB Keyboard Features
Product Reference Guide 6-167
Keyboard Interface — Intercharacter Delay
Sets the delay between the end of one character and the beginning of the
next, in 10 millisecond increments.
To specify the intercharacter delay:
1. Scan the SWITCH bar code.
2. Scan the bar code below,
SET KEYBOARD WEDGE INTERCHAR-
ACTER DELAY
. You’ll need to cover any unused bar codes on this
and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate digits from the keypad in
Appendix C that rep-
resent the desired delay. The selectable range is 0-100, which is the
delay in 10-millisecond increments. Pad all single and double digit
numbers with leading zeroes to yield a three-digit entry (000-100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SET KEYBOARD WEDGE INTERCHARACTER DELAY
To Next Page
Loading...
Need help?
General
