6-142 Magellan
®
8300/8400
Single Cable Manufacturer Extensions
Enables/Disables manufacturer
1
extensions to the Single Cable RS-232
interface. These extensions communicate scale calibration information to
the host.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
SINGLE CABLE MANUFACTURER EXTENSIONS = DISABLE
SINGLE CABLE MANUFACTURER EXTENSIONS = ENABLE
1. The manufacturer of the scanner.
To Next Page
Loading...
Need help?
General
