6-276 Magellan
®
8300/8400
Code 39 Start Stop Character Transmission
Enables/disables transmission of Code 39 start and stop characters.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
CODE 39 START STOP CHARACTER TRANSMISSION = DISABLE
CODE 39 START STOP CHARACTER TRANSMISSION = ENABLE
NOTE
This feature applies only when Code 39 Check Character Calculation is
enabled.
To Next Page
Loading...
Need help?
General
