Datalogic PowerScan PBT7100 User Manual

Getting Started
6 PowerScan
TM
PBT7100 Cordless
Setting Up the Reader and Base Station
Follow the steps provided in this section to connect and get your reader up and commu-
nicating with its host:
1. Install the Battery in the Reader
2. Connect the Base Station
3. Select the Interface Type
4. Configure Interface Settings (only if not using factory settings for that interface)
5. Configure Other Features (if modifications are needed from factory settings)
Install the Battery in the Reader
Follow the instructions in the Quick Reference Guide (QRG) to install the battery pack
and verify reader operation.
Connect the Base Station
Figure 1 shows how to connect the Base Station to a terminal, PC or other host device.
Turn off the host before connection and consult the manual for that equipment (if nec-
essary) before proceeding. Connect the interface cable before applying power to the Base
Station.
Base Station Connection and Routing — Fully insert the Power Cable and Interface
(I/F) Cable connectors into their respective ports in the underside of the Base Station (see
Figure 1), then plug the Base Station AC Adapter into the AC outlet. Alternatively, you
can either loop the cables around the routing clips and back through the routing channel
to the front of the Base Station as shown, or the cables can be fed directly out the back
of the Base Station via the routing clips.
Figure 1 . Connecting the Base Station
Bottom of Base Station
Routing
Clips
Base
Station
I/F Cable
Power Cable
Routing
Channel
Power Cable
AC
Adapter
I/F
Cable

Datalogic PowerScan PBT7100 Specifications

General

Brand	Datalogic
Model	PowerScan PBT7100
Category	Barcode Reader
Language	English