Getting Started
10
PowerScan
TM
PBT7100 Cordless
Select the Interface Type
Upon completing the physical connection between the Base Station and the host, pro-
ceed directly to Interfaces on page 13 for information and programming for the inter-
face type the Base Station is connected to (for example: RS-232, Keyboard Wedge, USB,
etc.) and scan the appropriate barcode in that section to select your system’s correct in-
terface type.
Configure Interface Settings
Each interface type is associated to a specific set of default features. If after scanning the
interface barcode from the Interfaces section, your installation requires you to select op-
tions to further customize your reader, turn to the appropriate section for your interface
type as listed below:
• RS-232 ONLY Interface, starting on page 47
• RS-232/USB-Com Interfaces, starting on page 53
• Keyboard Interface, starting on page 73
• USB-OEM Interface, starting on page 87
• IBM 46XX Interface, starting on page 91
• Wand Emulation Interface, starting on page 97
Configure Other Features
If your installation requires different programming than the standard factory default set-
tings, the following sections of this manual allow configuration of non-interface-specific
settings you might require:
General Features
—
General Features includes programming for scanning, beeper and
LED indicators and other such universal settings.
Symbologies
—
Includes options concerning the barcode label types (symbologies).
These settings allow you to enable/disable symbologies, set label lengths, require check
digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard in-
terfaces by scanning the following label.
Transmit Software Version
To Next Page
Loading...
