Datamax E-Class Mark II Programmer's Manual

Extended System-Level Command Functions
96 Class Series 2 Programmer’s Manual
Values Scanner Configuration Range / Interpretation
Redundancy Level – An alternative data integrity method, where the selected
level sets the number of consecutive, identical decodes required to pass the
bar code. If differing values are read, the count is restarted, where:
0 = Auto Mode
1 = read code 1X
2 = read code 2X
3 = read code 3X
4 = read code 4X
5 = read code 5X
6 = read code 6X
7 = read code 8X
8 = read code 10X
9 = read code 12X
A = read code 15X
B = read code 20X
C = read code 25X
D = read code 30X
E = read code 35X
F = read code 40X
G = read code 45X
V

Depending upon the print speed, higher Redundancy Levels may
cause erroneous failures when scanning multiple or small bar codes.
Table 5-11: Scanner Configuration Set Command
Example: <STX>KcSNC00H4MAB12YV0<CR>
The example above sets the printer to sense the scanner automatically, to read a
variable number of UPC bar codes, and to pass only those codes where a ¼ inch
zone has identical reads.

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz