Deep Sea Electronics Plc DSE8810 Software Manual

Edit Configuration
104
4.13.7 DSE2548 LED EXPANSION
Select the DSENet ID of the LED expansion you wish to configure. The ID of the Annunciator is set by rotary
decimal switch accessible on the back of the device.
The following is then shown:
Click to enable or disable the option. The relevant values
below will appear greyed out if the option is disabled.
Select the alarm type of the link lost alarm. This alarm will
take action if the expansion module is not detected by the
host module.
 - If the mute / lamp test button is
pressed, other DSE2548 modules
configured to Follow main unit and the
host module will also lamp test / mute
their alarm and vice-versa.
 - If the mute / lamp test button is
pressed, other DSE2548 modules and
the host module will not respond to this.
Enable or disable the expansion
module’s internal sounder.
Select the configuration for the
LED. For instance this LED is
configured to be unlit when in auto
mode. Hence this is a not in auto
LED.

Deep Sea Electronics Plc DSE8810 Specifications

General

Brand	Deep Sea Electronics Plc
Model	DSE8810
Category	Controller
Language	English