EasyManuals Logo

Deep Sea Electronics Plc DSE8810 Software Manual

Deep Sea Electronics Plc DSE8810
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
Edit Configuration
83
4.9.2.3 SMS CONTROL
The SMS commands listed below.
Timer
Code
Description
Remote Start off load
1 If this input is active, operation will be similar to the ‘Remote Start on
load’ function except that the generator will not be instructed to take the
load. This function can be used where an engine only run is required
e.g. for exercise.
Remote Start on load
2 When in auto mode, the module will perform the start sequence and
transfer load to the generator.
Cancel
3 By sending cancel code will cancel SMS remote start off load or SMS
Remote start on load, If the unit was in Auto mode the unit will stop and
the module with remain in Auto mode
Stop mode
4 This input mimic’s the operation of the ‘Stop’ button and is used to
provide a remote SMS stop command.
Auto Mode
5 This input mimics the operation of the “AUTO” button
Tick to enable the commands
that can be implemented upon
receiving a SMS message

Table of Contents

Other manuals for Deep Sea Electronics Plc DSE8810

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Deep Sea Electronics Plc DSE8810 and is the answer not in the manual?

Deep Sea Electronics Plc DSE8810 Specifications

General IconGeneral
BrandDeep Sea Electronics Plc
ModelDSE8810
CategoryController
LanguageEnglish

Related product manuals