Deep Sea Electronics Plc DSE8810 Software Manual

Scada
139
5.16.3 EXPANSION CALIBRATION
This section allows the analogue sensor inputs of the DSE2130 input expansion modules to be calibrated to
remove inaccuracies caused by the tolerance of the sensor devices. The engine can be running when the
instruments are calibrated and reference should be made to a third party accurate sensing device to ensure
accurate recalibration.
5.16.4 HOURS RUN AND NUMBER OF STARTS
This section allows the Hours Run and Number of Starts to be customised on the controller.
Typically, this is used when fitting a new controller to an older generator so that the controller display matches
the amount of work previously done by the system.
5.16.5 TIME
Type the value
or click the up
and down
arrows to
change the
settings
Click to perform
the adjustment
on the module
Display of the
module’s
current date
and time
Type the new
date / time or
click the up and
down arrows to
change the
settings
Click Set to
adjust the
module to the
selected
date/time.
Click Set to adjust the
module to the
date/time that your PC
is set to.

Deep Sea Electronics Plc DSE8810 Specifications

General

Brand	Deep Sea Electronics Plc
Model	DSE8810
Category	Controller
Language	English