Edit Configuration
93
4.13.1 DSE2130 INPUT MODULES
Select the DSENet ID of the input expansion you wish to configure. The ID of the expansion input module is
set by rotary decimal switch accessible under the removable cover of the device.
The following is then shown:
4.13.1.1 DIGITAL INPUTS (A-D)
Click to enable or disable the
option. The relevant values below
will appear greyed out if the option
is disabled.
Select the alarm type of the link
lost alarm. This alarm will take
action if the expansion module is
not detected by the host module.
Select which of the expansion
inputs you wish to configure.
Select the required function of the
input and whether it is open or
close to activate.
Select the required alarm type of
the input and when it is active.
Type the text that is to appear on
the module’s display when the
alarm is active.
Gives a delay upon activation of the
input to allow the input to be used as a
level switch for example.
To Next Page
Loading...
Need help?
General
