SCADA
138
5.16 MAINTENANCE
The Maintenance section is subdivided into smaller sections.
Select the required section with the mouse.
5.16.1 RECALIBRATE TRANSDUCERS
This section allows the analogue sensor inputs to be calibrated to remove inaccuracies caused by the
tolerance of the sensor devices. The engine can be running when the instruments are calibrated and
reference should be made to a third party accurate sensing device to ensure accurate recalibration.
Click and drag the
control until the
display beneath
matches the
reference meter
being used to
calibrate against.
Click to reset the
custom calibration
back to factory
default settings
To Next Page
Loading...
