Edit Configuration
98
4.13.2.1 EDITING THE SENSOR CURVES
Click and drag the
points on the
graphs to change
the settings
Click OK to accept
the changes and
return to the
configuration editor
Click CANCEL to
ignore and lose any
changes you have
made
Click SAVE AS, you are prompted to name
your curve....
Click OK to save the curve.
Any saved curves become selectable in the
Input Type selection list.
Hint:
Deleting, renaming or
editing custom sensor curves
that have been added is
performed in the main menu,
select Tools | Curve Manager.
Click Interpolate then select
two points as prompted to
draw a straight line between
them.
To Next Page
Loading...
Need help?
General
