Deep Sea Electronics Plc DSE8810

To Next Page

To Previous Page

4.13.2

DSE2131 RATIOMETRIC

Select the DSENet ID of the input expansion you wish to configure. The ID of the expansion input module is

set by rotary decima

l switch accessible under the removable cover of the device.

The following is then shown:

Edit Configuration

DSE2131 RATIOMETRIC

EXPANSION INPUT MODULE

Select the DSENet ID of the input expansion you wish to configure. The ID of the expansion input module is

l switch accessible under the removable cover of the device.

Click to enable or disable the

option. The relevant values below

will appear

greyed out

is disabled.

Select the alarm type of the

lost alarm

. This alarm will take

action if the expansion module is

not detected by the host module.

Click to configure the inputs

Then select which input you want

to configure

Select the DSENet ID of the input expansion you wish to configure. The ID of the expansion input module is

Click to enable or disable the

option. The relevant values below

greyed out

if the option

Select the alarm type of the

link

. This alarm will take

action if the expansion module is

not detected by the host module.

Click to configure the inputs

Then select which input you want

Other manuals for Deep Sea Electronics Plc DSE8810