Deep Sea Electronics Plc DSE8810

Edit Configuration
79
4.9.2 RS232 PORT
4.9.2.1 BASIC
SERIAL PORT CONFIGURATION
Timer
Description
Port usage
No
Modem
– RS232 ports is used for direct RS232 connection to PLC, BMS etc
Incoming modem calls – RS232 port connected to modem, used to accept
incoming calls only.
Incoming and outgoing modem (Sequence) – RS232 port connected to modem
used to accept incoming calls and also make calls upon shutdown alarms.
Outgoing modem alarms (Sequence) - RS232 port connected to modem, used to
make calls upon shutdown alarms.
Incoming and outgoing modem (Cyclic) – RS232 port connected to modem used
to accept incoming calls and also make calls upon shutdown alarms.
Outgoing modem alarms (Cyclic) - RS232 port connected to modem, used to
make calls upon shutdown alarms.
Selects how the port is to
be used
Baud rate adjustable
from 1200-115200
These items are
greyed out until a
relevant option in Port
Usage is selected.
Modbus Slave ID
Sends Alarm
messages as a flash
instant message
Sends extended
instrumentation with
the Alarm code
(Oil pressure / Coolant
temp / HRS run
Select for GSM
modem type