Deif PPU 300 - Delete Backups

Controller type Prerequisites
3. The controller must be under switchboard control.
SHAFT generator controller
1. The breaker must be opened.
2. The controller must be under switchboard control.
SHORE connection controller
BUS TIE breaker controller
To restore a controller backup file, perform the following steps:
1. Ensure the prerequisites for your controller type are met.
2. Select Tools from the Home menu.
3. Select Restore from the Tools menu.
4. Highlight the backup that you want to restore using Up or Down .
5. Start the restore procedure by pressing OK .
INFO
If you are not already logged on, you are prompted to do so.
6. Select the data you want to restore.
a. Highlight the data you want to restore using Up or Down .
b. Select the data by pressing OK .
7. You can now either:
• Restore the data by selecting Restore
Restore
.
◦ You are prompted to confirm that you want to restore the selected data:
◦
◦ Press OK to confirm restoring the selected data.
CAUTION
The controller will now restore the data and restart.
• Press Back to cancel restoring the data.
10.1.3 Delete backups
View the controller backups and delete backups under
Tools > Restore.
Deleting backups
To delete a controller backup file, perform the following steps:
OPERATOR'S MANUAL 4189341099G UK Page 106 of 130