5. When all change(s) have been made, select Write .
6. For changes to take effect, you must power off and on the controller rack and restart the display unit.
DANGER!
For changes to communication settings to take effect, all controllers and displays in the same system MUST only be
powered off and powered on. This must be done by authorised personnel who understand the risks involved in accessing
the power supply or installation design. Take extreme care in the enclosure next to the ACM terminals. Ensure the
controllers are not running and in operation, and that the controlled breakers are open before powering off and on the
controllers and display units.
10.6 Lamp test
10.6.1 Lamp test
Run the Lamp test under Tools > Advanced > Lamp test.
Run lamp test
To run the lamp test, perform the following steps:
1. Select Tools, from the Home menu.
2. Select Advanced, from the Tools menu.
3. Highlight Lamp test, from the Advanced menu.
4. Run the lamp test by pressing OK
.
• All of the display LEDs now colour cycle until complete.
During the lamp test a message box is shown on the display unit.
Press Stop
to abort the lamp test.
10.7 Brightness
10.7.1 About brightness menu
The brightness menu
allows you to do the following:
OPERATOR'S MANUAL 4189341099G UK Page 114 of 130
To Next Page
Loading...
