Deif PPU 300 - Configure Alarm(S)

7.9.5 Configure alarm(s)
Create a new analogue custom alarm
To create a new alarm, edit one of the available Analogue custom alarms listed.
INFO
Give the alarm a descriptive name, for easier reference.
•
1. Highlight a previously unused alarm, by pressing Up or Down .
2. Select and enable the alarm by pressing OK
.
• Enabled alarm(s) are shown with a solid box.
3. Select Edit
Edit
.
• Details of the alarm settings are shown on the display for you to configure.
•
a. Highlight the required alarm setting, by pressing Up or Down .
b. To change the setting, press OK .
◦ If the setting is Enable or Not enabled, pressing OK toggles either Enable or Not enabled.
◦ Enabled settings are marked with a solid box.
OPERATOR'S MANUAL 4189341099G UK Page 66 of 130