◦ If the setting is text or a value, pressing OK displays the virtual keyboard to alter the setting.
◦ Make the required changes using the virtual keyboard.
◦ To confirm the changes, select Next
.
◦ If the setting is a selection, pressing OK displays an available list of selection options.
◦ Highlight the option required, by pressing Up
or Down .
◦ Select or unselect the option, by pressing OK .
◦ To confirm the setting, select Next
.
c. Once you have made all the required changes to the alarm settings, select Write .
◦ This saves the alarm setting to the controller. This does not save any other settings.
◦ The list of available alarms is shown again on the display.
Select an existing analogue custom alarm
You can use or edit an existing Analogue custom alarm.
•
1. Highlight the required custom alarm, by pressing Up or Down .
2.
Select Edit
.
• Details of the alarm settings are shown on the display for you to configure.
•
OPERATOR'S MANUAL 4189341099G UK Page 67 of 130
To Next Page
Loading...
