Deif PPU 300 - Configure Alarm(S)

• Highlight the required function, by pressing Up or Down .
◦
• Enable the highlighted function by pressing OK .
◦ Selected function(s) are shown with a solid box.
◦
• To clear all the Enabled functions, select Clear
Clear
.
• To save the setting(s) to the controller, select Write
.
◦ This only applies to the selected functions and does not apply to other I/O change(s).
7.7.3 Configure alarm(s)
Create a new digital custom alarm
To create a new alarm, simply edit one of the available Digital custom alarms listed.
INFO
It is recommended to give your created alarms a new descriptive name for easier reference.
OPERATOR'S MANUAL 4189341099G UK Page 54 of 130