2. Highlight the required user by pressing Up or Down .
3. Select the highlighted user by pressing OK .
• The virtual keyboard is displayed on screen.
• You must enter the password for the selected user.
• Or you can cancel the log on by pressing Back
to return to the previous list of users.
4. Enter the password by using the virtual keyboard.
• See Using the display unit, Introduction, About the virtual keyboard for more information on how to use the
keyboard and layouts.
5. Select Log on
.
• If the password is correct, you are logged on as the new user.
◦ The Home menu is then displayed on screen.
◦
◦ A logged on icon is shown in the top right of the display (1).
• If the password is entered in incorrectly, the following message is displayed:
◦
◦ The message automatically closes after a couple of seconds, or you can press OK .
◦ To attempt to log on again, continue again from step 2 above.
INFO
You do not need to log off a user to log on as different one. You can simply log on as the new user.
6.3 Log off
6.3.1 Log off from controller
Log off from the display under
Log on.
OPERATOR'S MANUAL 4189341099G UK Page 27 of 130
To Next Page
Loading...
