Deif PPU 300 - View or Configure Sensor

a. Highlight the required alarm setting, by pressing Up or Down .
b. To change the setting, press OK .
◦ If the setting is Enable or Not enabled, pressing OK toggles either Enable or Not enabled.
◦ Enabled settings are marked with a solid box.
◦ If the setting is text or a value, pressing OK
displays the virtual keyboard to alter the setting.
◦ Make the required changes using the virtual keyboard.
◦
To confirm the changes, select Next
Next
.
◦ If the setting is a selection, pressing OK displays an available list of selection options.
◦ Highlight the option required, by pressing Up or Down .
◦ Select or unselect the option, by pressing OK .
◦ To confirm the setting, select Next
Next
.
c. Once you have made all the required changes to the alarm settings, select Write .
◦ This saves the alarm setting to the controller. This does not save any other settings.
◦ The list of available alarms is shown again on the display.
3. To save the new setting to the controller, select Write
.
• This only saves the selected alarm(s) and their settings to the controller. It does not save other I/O settings.
Clear all enabled alarm(s)
1. To clear all the selected alarms, select Clear
Clear
.
2. To save the new setting to the controller, select Write .
• This only saves the selected alarm(s) and their settings to the controller. It does not save other I/O settings.
7.9.6 View or configure sensor
INFO
Configure any required function(s) before configuring the sensor settings.
More information
See Analogue input (AI), Configure function(s) for more information.
Configure the Sensor
1. To configure the Sensor, select Sensor
Sensor
.
• A list of available output types are shown on the display.
OPERATOR'S MANUAL 4189341099G UK Page 68 of 130