•
◦ : The controller paired to the display unit. (If already paired).
◦ ID: The controller ID.
◦ Label: The controller label.
◦ Host name: The host name from the controller.
◦ Hops: The number of hops used to reach the controller.
INFO
The number of hops shown indicate how close the controller may be to the display unit. 1 hop typically indicates that
the controller is directly plugged in to the display unit.
3. Highlight the controller you wish to pair with, by pressing Up or Down .
•
INFO
The current paired controller (if already paired) is marked with a green dot .
4. Select the controller by pressing OK .
• A confirmation is displayed on screen.
OPERATOR'S MANUAL 4189341099G UK Page 39 of 130
To Next Page
Loading...
