Dell S3048-ON User Manual

To reset the number of FP blocks to the default, use the no version of these commands. By default, zero groups are allocated for the ACL
in VCAP. ACL VLAN groups or CAM optimization is not enabled by default. You must also allocate the slices for CAM optimization.
To display the number of FP blocks that is allocated for the dierent VLAN services, use the show cam-acl-vlan command. After you
congure the ACL VLAN groups, reboot the system to store the settings in nonvolatile storage. During CAM initialization, the chassis
manager reads the NVRAM and allocates the dynamic VCAP regions.
106 Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)

Dell S3048-ON Specifications

General

Rack Units	1U
Form Factor	Rack-mountable
Input Voltage	100-240V AC
Power Supply	2 hot-swappable power supplies
Management	CLI, Web, SNMP
Product Type	Switch
MAC Address Table Size	32K entries
Jumbo Frame Support	Yes
Latency	< 3 microseconds
Ports	48 x 1GbE RJ45, 4 x 10GbE SFP+