Figure 58. Inspecting the LAG Status Using the show lacp command
The point-to-point protocol (PPP) is a connection-oriented protocol that enables layer two links over various dierent physical layer
connections. It is supported on both synchronous and asynchronous lines, and can operate in Half-Duplex or Full-Duplex mode. It was
designed to carry IP trac but is general enough to allow any type of network layer datagram to be sent over a PPP connection. As its
name implies, it is for point-to-point connections between exactly two devices, and assumes that frames are sent and received in the same
order.
434
Link Aggregation Control Protocol (LACP)
To Next Page
Loading...
