Dell S3048-ON User Manual

Conguring the Enable Password Command
To congure Dell Networking OS, use the enable command to enter EXEC Privilege level 15. After entering the command, Dell
Networking OS requests that you enter a password.
Privilege levels are not assigned to passwords, rather passwords are assigned to a privilege level. You can always change a password for any
privilege level. To change to a dierent privilege level, enter the
enable command, then the privilege level. If you do not enter a privilege
level, the default level 15 is assumed.
To congure a password for a specic privilege level, use the following command.
• Congure a password for a privilege level.
CONFIGURATION mode
enable password [level level] [encryption-mode] password
Congure the optional and required parameters:
• level level: Specify a level from 0 to 15. Level 15 includes all levels.
• encryption-type: Enter 0 for clear text, 7 for DES-encrypted text, or 8 for sha256-based encrypted text.
• password: Enter a string.
To change only the password for the enable command, congure only the password parameter.
To view the conguration for the enable secret command, use the show running-config command in EXEC Privilege mode.
In custom-congured privilege levels, the enable command is always available. No matter what privilege level you entered Dell Networking
OS, you can enter the enable 15 command to access and congure all CLIs.
Conguring Custom Privilege Levels
In addition to assigning privilege levels to the user, you can congure the privilege levels of commands so that they are visible in dierent
privilege levels.
Within Dell Networking OS, commands have certain privilege levels. With the privilege command, you can change the default level or
you can reset their privilege level back to the default.
• Assign the launch keyword (for example, configure) for the keyword’s command mode.
• If you assign only the rst keyword to the privilege level, all commands beginning with that keyword are also assigned to the privilege
level. If you enter the entire command, the software assigns the privilege level to that command only.
To assign commands and passwords to a custom privilege level, use the following commands. You must be in privilege level 15.
1 Assign a user name and password.
CONFIGURATION mode
username name [access-class access-list-name] [privilege level] [nopassword | password
[encryption-type] password Secret]
Congure the optional and required parameters:
• name: Enter a text string up to 63 characters(maximum) long.
• access-class access-list-name: Restrict access by access-class..
• privilege level: The range is from 0 to 15.
• nopassword: No password is required for the user to log in.
• encryption-type: Enter 0 for plain text or 7 for encrypted text.
• password: Enter a string. Specify the password for the user.
704
Security

Dell S3048-ON Specifications

General

Rack Units	1U
Form Factor	Rack-mountable
Input Voltage	100-240V AC
Power Supply	2 hot-swappable power supplies
Management	CLI, Web, SNMP
Product Type	Switch
MAC Address Table Size	32K entries
Jumbo Frame Support	Yes
Latency	< 3 microseconds
Ports	48 x 1GbE RJ45, 4 x 10GbE SFP+