EasyManua.ls Logo

Dell S3048-ON - Page 981

Dell S3048-ON
1036 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To congure simple authentication, use the following command.
Congure a simple text password.
INTERFACE-VRID mode
authentication-type simple [encryption-type] password
Parameters:
encryption-type: 0 indicates unencrypted; 7 indicates encrypted.
password: plain text.
Examples of the authentication-type Command
The bold section shows the encryption type (encrypted) and the password.
Dell(conf-if-gi-1/1-vrid-111)#authentication-type ?
Dell(conf-if-gi-1/1-vrid-111)#authentication-type simple 7 force10
The following example shows verifying the VRRP authentication conguration using the show conf command. The bold section shows
the encrypted password.
Dell(conf-if-gi-1/1-vrid-111)#show conf
!
vrrp-group 111
authentication-type simple 7 387a7f2df5969da4
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
Disabling Preempt
The preempt command is enabled by default. The command forces the system to change the MASTER router if another router with a
higher priority comes online.
Prevent the BACKUP router with the higher priority from becoming the MASTER router by disabling preempt.
NOTE
: You must congure all virtual routers in the VRRP group the same: you must congure all with preempt enabled or
congure all with preempt disabled.
Because preempt is enabled by default, disable the preempt function with the following command.
Prevent any BACKUP router with a higher priority from becoming the MASTER router.
INTERFACE-VRID mode
no preempt
Examples of Disabling Preempt
Re-enable preempt by entering the preempt command. When you enable preempt, it does not display in the show commands, because it
is a default setting.
The following example shows how to disable preempt using the no preempt command.
Dell(conf-if-gi-1/1)#vrrp-group 111
Dell(conf-if-gi-1/1-vrid-111)#no preempt
Dell(conf-if-gi-1/1-vrid-111)#
The following example shows how to verify preempt is disabled using the show conf command.
Dell(conf-if-gi-1/1-vrid-111)#show conf
!
vrrp-group 111
authentication-type simple 7 387a7f2df5969da4
Virtual Router Redundancy Protocol (VRRP)
981

Table of Contents

Related product manuals